URKIRAPID J-13 Q/D Synthetic Enamel

j13 sintetico urki esmalte detail rapid

DESCRIPTION

Quick-drying enamel for interior and exterior use. It stands out for its high coverage, good body, quick drying and matte appearance.

It is ideal for painting bodywork parts, smithy work and machinery in general.

IMPLEMENTATION PROCESS

APPLICATION

Application
viscosity
Dilution %
20-25”
URKISOL 300
20-25%
Gravity gun
Application pressure
1,3 – 1,5 mm
3-4 bar
Number of coats
Total thickness
2 coats
20-30 μm
Flash time5-10’
Drying Time
20°C

30’
% Gloss 60°-60°<5

Can be repainted after 24 hours.

SURFACE PREPARATION

On steel: The surfaces to be painted must be properly derusted and degreased.

For a better adhesion and protection of the support, it can be previously primed with F-29 or F-809.

On old paint, sand and degrease previously.

RELATED INFORMATION

SAFETY INSTRUCTIONS

The use of appropriate personal protective equipment is recommended during application, to prevent the irritation of the respiratory tract, skin and eyes. For professional use only.

STORAGE

Keep in a tightly covered container, in a dry and ventilated place, avoiding direct exposure to sunlight. Temperature above 5°C is recommended, between 15 and 30°C optimal.

VOC

The VOC content of URKIRAPIDJ-13 is a maximum of 550 g/l.

PRODUCT NOTE

The information contained in this Technical Specification Sheet is based on the knowledge and experience of the BESA technical department, and with it it’s intended to advice and inform, being the responsibility of the user to take the necessary measures to guarantee the intended purpose of the product. FOR PROFESSIONAL USE ONLY.

Enter your data

Select the language of the sheet to download