Anti-stone chip gun Application pressure	4-5 bar
	Number of coats Total thickness	1 cross coat 350-400 μm
	Drying Time 20°C 60°C	60’ 30’ Do not dry with infrared lamps: Blistering may occur.

URKIPROTEC HS PLUS is repaintable after 45 minutes from application (at 20-25°C). After 8 hours, light sanding is recommended before painting.

Shake the can before inserting it into the gun.

Apply one cross-coat to achieve up to 400 microns (500-550 microns wet). If multiple coats are applied, the total thickness should not exceed 1000 microns.

Surfaces must be clean, dry and exempt of dust, grease and rust. For better adhesion of the product, peeling parts, dirt and rust must be removed.

The use of appropriate personal protective equipment is recommended during application, to prevent the irritation of the respiratory tract, skin and eyes. For professional use only.

Keep in a tightly covered container, in a dry and ventilated place, avoiding direct exposure to sunlight. Temperature above 5 °C is recommended, between 15 and 30 °C optimal.

The VOC content of URKIPROTEC HS PLUS is a maximum of 430 g/l in compliance with European regulation 2004/42/EC IIB(E) (840) <840 g/l.

The information contained in this Technical Specification Sheet is based on the knowledge and experience of the BESA technical department, and with it it’s intended to advice and inform, being the responsibility of the user to take the necessary measures to guarantee the intended purpose of the product. FOR PROFESSIONAL USE ONLY.