Flexible paint specially formulated for painting vehicle bumpers. It has a satin textured appearance that imitates the original finishes.
It can be used as an anchorage primer for plastics. Repainting is possible with 2K single-coat and waterborne bi-coat systems.
A wide variety of textures can be achieved by varying the application parameters: distance, flow, pressure, nozzle, etc.
Shake can | 2-3’ | ||
Painting distance | 20-30 cm | ||
Number of coats Total thickness | 2-3 coats 40-60 μm | ||
Flash time | 5-10’ | ||
Drying Time 20°C | 30’ | ||
% Gloss 60°- 60° | Matt |
Shake the can for 2-3 minutes before using SPRAY URKIPLAST. Apply 2-3 coats, depending on the texture, leaving 5-10 minutes between coats. After use, invert the can and clean the valve.
Can be repainted after 4 hours.
Remove dirt with soap and water. Once the surface to be painted is dry, degrease it with URKISOL 94 Plastic Cleaner. Must be free of oil stains or tar.
The use of appropriate personal protective equipment is recommended during application, to prevent the irritation of the respiratory tract, skin and eyes. For professional use only.
Keep in a tightly covered container, in a dry and ventilated place, avoiding direct exposure to sunlight. Temperature above 5 °C is recommended, between 15 and 30 °C optimal.
CAUTION: Under no circumstances should the packaging exceed 50 °C.
The VOC content of URKIPLAST Spray is a maximum of 840 g/l in compliance with European regulation 2004/42/EC IIB(E) (840) <840 g/l.
The information contained in this Technical Specification Sheet is based on the knowledge and experience of the BESA technical department, and with it it’s intended to advice and inform, being the responsibility of the user to take the necessary measures to guarantee the intended purpose of the product.
FOR PROFESSIONAL USE ONLY.