Shake can	2-3’
	Painting distance	20-30 cm
	Number of coats Total thickness	2-3 cross coats 30-40 μm
	Flash time	5-10’
	Drying Time 20°C	20’
	% Gloss 60°-60°	Satin

Shake the can for about 2-3 minutes before using URKILAC. Apply 2-3 thin coats leaving 5-10 min. between them.

After use, invert the can and clean the valve.

Can be recoated after 24 hours.

On steel: The surfaces to be painted must be properly derusted and degreased.

For a better adhesion and protection, the support can be previously primed with F-286/2.

On old paints that are well adhered, sand previously.

The use of appropriate personal protective equipment is recommended during application, to prevent the irritation of the respiratory tract, skin and eyes. For professional use only.

Keep in a tightly covered container, in a dry and ventilated place, avoiding direct exposure to sunlight. Temperature above 5°C is recommended, between 15 and 30°C optimal.

CAUTION: Under no circumstances should the packaging exceed 50°C.

The VOC content of SPRAY URKILAC is a maximum of 840 g/l in compliance with European regulation 2004/42/EC IIB(E)(840) <840 g/l.

The information contained in this Technical Specification Sheet is based on the knowledge and experience of the BESA technical department, and with it it’s intended to advice and inform, being the responsibility of the user to take the necessary measures to guarantee the intended purpose of the product. FOR PROFESSIONAL USE ONLY.