URKIFLY 2K UHS Express Clearcoat

detail fly 1 urki
General Information
Hardeners
E-253
Can size

DESCRIPTION

UHS clearcoat developed exclusively for partial, SPOT REPAIR. It stands out for its hardening speed, making possible to have the vehicle operational 40’ after the application of the clearcoat without need of heating the booth. This allows savings from energy in the painting cycle, as well as an increase in productivity.

A 10 min drying process can be done in the booth at 60°C or at 40°C for 20’. By IR-drying, 5 min.

URKIFLY can be polished approximately 1 hour after drying.

Excellent gloss finish, extensibility, with resistance to UV rays, abrasion and chemical agents are obtained.

HARDENERS

As it’s a product conceived for SPOT REPAIR, where speed of work is required, it has been designed to be used with one single ultra-fast hardener.

Hardener
E-253 Ultra Fast

IMPLEMENTATION PROCESS

APPLICATION

ULTRA FAST E-253
Mixing ratio
Volume
Weight
2:1 V
100:52 P
Pot-life30’
Application
viscosity
Dilution %
18-20”
Thinner is not required
Gravity Gun
Application pressure
1,2 mm
2-2,5 bar
Number of coats
Total thickness
2 coats
50-60 μm
Flash time5-7’ between coats
20’ before accelerating drying
Drying Time
20°C
IR Medium wave
60°C
40’
5’
10’
Polishing
20°C
IR Medium wave
60°C
After drying in each case
1h.
1h.
1h.

Best results are achieved with 1.2mm fluid peak. Apply two crossed-coats with an interval of 5 to 10 min. to allow flash-off.

It can be used between 5°C and 35°C. The product has been tested in extreme humidity and heat conditions.

After applying the URKIFLY clearcoat, it is recommended to use URKIBLEND spray in areas where it may have been oversprayed, in order to achieve full integration of the applied clearcoat with the previous’ film.

The application must be done in the 30 min. lapse after mixing of both components. Both clearcoat and hardener’s cans must be closed after each use.

SURFACE PREPARATION

Sprayed directly over the basecoat (both solvent and water-based) after at least 30 min. from its application.

When using water-based undercoats it is very important to ensure that the water has completely evaporated before applying the clearcoat.

The use of BESA Tack Cloths is recommended before applying it.

MIXING RATIOS

100g250g500g1000g
URKIFLY66165330660
HARDENER3485170340

RELATED INFORMATION

SAFETY INSTRUCTIONS

The use of appropriate personal protective equipment is recommended during application, to prevent the irritation of the respiratory tract, skin and eyes. For professional use only.

STORAGE

Keep in a tightly covered container, in a dry and ventilated place, avoiding direct exposure to sunlight. Temperature above 5°C is recommended, between 15 and 30°C optimal.

VOC

The VOC content of URKIFLY is a maximum of 420 g/l, , in compliance with European standard 2004/42/CE IIB(D) (420) <420 g/l.

PRODUCT NOTE

The information contained in this Technical Specification Sheet is based on the knowledge and experience of the BESA technical department, and with it it’s intended to advice and inform, being the responsibility of the user to take the necessary measures to guarantee the intended purpose of the product.
FOR PROFESSIONAL USE ONLY
.

General Information
Hardeners
E-253
Can size

Enter your data

Select the language of the sheet to download