2K Tin Polyester Putty | URKI-TINE

7000 Grey

Hardeners	Adherence
BPO	Steel

1.5KG 8 Pcs x box

Polyester putty formulated with a special metallic pigment composition that provides it with smooth consistency.

Unlike conventional fillers it hardly contracts due to its low density. It stands out for its hardness, great resistance to high temperature, abrasion, certain oils, acids, and flexibility to absorb vibrations and movements in the reparation process. Must be sanded when it’s dry with fiber or coarse-grained paper discs due to its hardness.

It has been conceived for bodywork such as door corners and wheel arches filling, particularly in older vehicles, smoothing or filling PU panels when it is not possible to use conventional putties due to their contraction, for filling deep gaskets in difficult areas where tinning

process is not possible, repair of rust holes, around the fuel tank nozzles, exterior mirrors and entrance areas, filling of slight dents and scratches on plastic bumpers as well as most parts plastic parts from automobiles.

The use of an electronic scale is recommended. Mix homogeneously to avoid the formation of air bubbles.

Hardener	Percentage	Temperature
BPO	3%	5-10°C
BPO	2%	10-20°C
BPO	1%	>20°C

Note: Adding more hardener is not recommended in order to prevent bleedings in the paint.

APPLICATION

		BPO
	Mixing ratio Weight	100:1-3 P
	Pot-life	3-4’
	Spatula Number of coats Total thickness	Avoid air bubble formation during its application. 1-3 coats 1000-3000 μm
	Drying Time 20°C IR Medium wave	30’ 5’
	Sanding	P80-P150

Application: By spatula.
The hardener mixture can be carried out on the same spatula, homogenizing it well before applying.

When a deep filling is required, apply several layers, letting them dry at each time during the process. Sanding at each stage is recommended in order to obtain better adhesion between the coats.

SURFACE PREPARATION

The surface to be repaired must be free of rust and grease, for which we recommend previous sanding (P80-P120). Good adherence is achieved on wood and previously sanded GRP.
Do not use this putty on wash-primer or phosphochromatic primers. If the original finish is thermoplastic acrylic, bare metal must be reached.
For greater substrate protection, it is recommended to coat first with a primer from BESA’s product line such as F-286/2.
Recoatable with any PUR or Epoxy finish once sealed preferably with 2K filler from the BESA product line.

MIXING RATIOS

Recommended mixes	100 g	250 g
BPO mix 3%	3	7,5
BPO mix 2%	2	5
BPO mix 1%	1	2,5

SAFETY INSTRUCTIONS

The use of appropriate personal protective equipment is recommended during application, to prevent the irritation of the respiratory tract, skin and eyes. For professional use only.

STORAGE

Keep in a tightly covered container, in a dry and ventilated place, avoiding direct exposure to sunlight. Temperature above 5ºC is recommended, between 15 and 30ºC optimal.

VOC

The VOC content of URKITINE is a maximum of 250 g/l in compliance with European standard 2004/42/CE IIB(B) (250) <250 g/l.

PRODUCT NOTE

The information contained in this Technical Specification Sheet is based on the knowledge and experience of the BESA technical department, and with it it’s intended to advice and inform, being the responsibility of the user to take the necessary measures to guarantee the intended purpose of the product.
FOR PROFESSIONAL USE ONLY.