BESAFIB Low Density Fiber Glass Putty

de fib fibra poliester detail vidrio besa masilla de
General Information
Hardeners Adherence
BPO Steel
Aluminum
Electro-zinc
GRP
Can size

DESCRIPTION

Fiberglass polyester putty designed for bodywork, railway equipment, machinery, vessel repairing, for filling dents, cracks, perforations or chips in steel, cast iron, aluminum, electro-galvanized galvanized steel or polyester fiber laminates of GRP glass. Also usable in the construction of models and prototypes where an easily mouldable material is required.

It stands out for its creamy consistency and easy application, its low density that allows a good filling power in layers of 2-4 mm., good resistance and sandability with finer grains than conventional putties. It increases the mechanical resistance of the repaired item.

HARDENERS

The use of an electronic scale is recommended. Mix homogeneously to avoid the formation of air bubbles.

HardenerPercentageTemperature
BPO3%5-10°C
BPO2%10-20°C
BPO1%>20°C

Note: Adding more hardener is not recommended in order to prevent bleedings in the paint.

APPLICATION PROCESS

APPLICATION

BPO
Mixing ratio
Weight
100:1-3 P
Pot-life3-5’
Spatula
Number of coats
Total thickness
Avoid air bubble formation during its application.
1-3 coats
1000-3000 μm
Drying Time
20°C
IR Medium wave
30’
5’
SandingP120-P320

Application: By spatula.
The hardener mixture can be carried out on the same spatula, homogenizing it well before applying.

When a deep filling is required, apply several layers, letting them dry at each time during the process. Sanding at each stage is recommended in order to obtain better adhesion between the coats.

SURFACE PREPARATION

The surface to be repaired must be free of rust and grease, for which we recommend previous sanding (P80-P120). On electro-zinc plating better use StarBrite.

Do not use this putty on wash-primer or phosphochromatic primers. If the original paint is thermoplastic acrylic, bare metal must be reached.

For greater substrate protection, especially in steel, use first a primer from BESA’s product line such as F-286/2.
Recoatable with any Acrylic or Epoxy finish system once sealed, preferably with a 2K filler from the BESA product line.

MIXING RATIOS

Recommended mixes100 g250 g
BPO mix 3%37,5
BPO mix 2%25
BPO mix 1%12,5

RELATED INFORMATION

SAFETY INSTRUCTIONS

The use of appropriate personal protective equipment is recommended during application, to prevent the irritation of the respiratory tract, skin and eyes. For professional use only.

STORAGE

Keep in a tightly covered container, in a dry and ventilated place, avoiding direct exposure to sunlight. Temperature above 5ºC is recommended, between 15 and 30ºC optimal.

VOC

The VOC content of BESAFIB is a maximum of 250 g/l in compliance with European standard 2004/42/CE IIB(B) (250) <250 g/l.

PRODUCT NOTE

The information contained in this Technical Specification Sheet is based on the knowledge and experience of the BESA technical department, and with it it’s intended to advice and inform, being the responsibility of the user to take the necessary measures to guarantee the intended purpose of the product.
FOR PROFESSIONAL USE ONLY.

General Information
Hardeners Adherence
BPO Steel
Aluminum
Electro-zinc
GRP
Can size

Enter your data

Select the language of the sheet to download