E-35
	Mixing ratio Volume	1 litre: 50 c.c.
	Pot-life	35-45’
	Application viscosity Dilution %	Mixing viscosity No thinner required
	Gravity gun Application pressure	2,8 mm 4,5 bar
	Number of coats Total thickness	2-3 manos 200-400 μm
	Flash time	3-5’ between coats
	Drying Time 20°C	3-4h.
	Sanding 20°C	P80-P100 3-4 h.

Application: Spraygun.

The surface to be repaired must be free of rust and grease, for which we recommend previous sanding (P80-P120).

Do not use this putty on wash-primer or phosphochromatic primers. If the original paint is thermoplastic acrylic, bare metal must be reached.

For greater substrate protection, especially in steel, use first a primer from BESA’s product line such as F-286/2.
Recoatable with any Acrylic or Epoxy finish system once sealed, preferably with a 2K filler from the BESA product line.

The use of appropriate personal protective equipment is recommended during application, to prevent the irritation of the respiratory tract, skin and eyes. For professional use only.

Keep in a tightly covered container, in a dry and ventilated place, avoiding direct exposure to sunlight. Temperature above 5°C is recommended, between 15 and 30°C optimal.

The VOC content of BESAROC is a maximum of 400 g/l.

The information contained in this Technical Specification Sheet is based on the knowledge and experience of the BESA technical department, and with it it’s intended to advice and inform, being the responsibility of the user to take the necessary measures to guarantee the intended purpose of the product.
FOR PROFESSIONAL USE ONLY.